8W/LF self regulating heating cable(s) CAN be used on PVC pipes. Generally, the maximum self regulating wattage temperature for PVC items is 95C (200F) the heaters in our range will not get anywhere near that in normal operation.
What is the maximum self regulating wattage on a PVC pipe? Read More »
The dual cable tester (DCT) cannot be used to measure the resistance of the floor sensor because it is not scaled to measure that high. The result will be O.L.
Can the dual cable tester be used to measure the resistance of the floor sensor? Read More »
Yes, both versions of the SNOPRO-100 require the high-limit sensors to be wired (terminals 10 & 11), either by the high-limit sensor that is included in both SNOPRO-100 or by putting in a 470k resistor as outlined on page 11 of our manual.
Does the SNOPRO-100 require a high-limit sensor? Read More »
Although it would depend on the total point load (aka ground pressure), the answer is no. Warmup’s Ultralight was designed to be used in foot-traffic applications only.
Point loads greater than Warmup’s Ultralight Compressive Strength (10% Compression) of 32 psi (220 kPa) may cause a future failure. Warmup recommends a rigid foam that meets the specifications for heavy-point load applications.
Can Ultralight be used under heavy loads such as a car? Read More »
Welcome to our informative post on setting heating limits for different types of flooring! When it comes to floor heating, it’s crucial to be aware of the specific limits to prevent any potential damage or discomfort. By following a few simple steps, you can easily set the heating limits on your thermostat and ensure a safe and cozy environment in your home. If you would like to watch a visual demonstration, please view the video below. Additionally, there are short format and full format instructions provided on how to set heating limits for your convenience.
How do I set heating limits on my Terra Thermostat? Read More »
Welcome to our informative post on learning more about the open window function on your Warmup Smart Thermostat. Follow along down below to read more about this function.
Why does my thermostat set into open window function and decreases my set temperature? Read More »
Yes, your thermostat can connect to your Google Home. Read the instructions down below to find out how!
Can my thermostat connect to Google Home? Read More »
Ultralight under concrete? Ultralight is designed for and can be used under concrete up to 2″ in thickness. When concrete is greater than 2″ the benefits of the Ultralight diminish, therefore, in concrete larger than 2″ we recommend the use of other insulating boards suitable for the specific application.
Can Ultralight be used under concrete? Read More »
There is no subfloor requirement specifically for Warmup’s Peel-and-Stick; it can even be installed over Epoxy. However, the subfloor is required to be: Level Smooth Clean Warmup recommends the smoothest plywood possible, such as sanded plywood, with a primer* for the best results. If your subfloor is OSB (aka chipped board), it is required to
What type of wood subfloor is required for Warmup’s Peel-and-Stick products? Read More »
Welcome to the guide on performing a Factory Reset for your Terra Smart WiFi Thermostat. In this tutorial, we will provide you with a video, short format and full instructions to ensure a smooth and successful reset process.
How do I perform a factory reset on my Terra Thermostat? Read More »
Warmup offers an extensive range of electric floor systems compatible with all floor types, rooms and projects.
![Thumbnail [200x250]](/wp-content/uploads/Indoor-Systems-Page-Image.png)
![Thumbnail [200x250]](/wp-content/uploads/image-13.png)
![Thumbnail [200x250]](/wp-content/uploads/Projects-Image.png)
