Where are the DIP switches located on the COMMBOX-600?

Further Questions?

Miscellaneous questions
- How long should I program my CommBox to melt snow?
- Will any third party sensor work with the CommBox or ResiBox?
- Can one AirSense be used with two CommBoxes?
Wiring
- How many Mats or Amps can I connect to the CommBox?
- Can I use the Commbox or Resibox with single phase electric?
- What are the amperage capabilities of each Box at each voltage?
- Do Warmup outdoor controls have GFEP protection?
- What is the largest breaker allowed by code to power a snow melting system?
Preparing for your project
- Do I need to provide a transformer to wire in 3-phase?
- Do I need more than one waterproofing kit?
- Do I need a waterproofing kit?
- Do Warmup outdoor controls have GFEP protection?
Programming
- Where are the DIP switches located on the COMMBOX-600?
- What do each of the COMMBOX DIP Switches Mean?
- Programming your COMMBOX-600
Troubleshooting
- What Does the HI/LO Error message mean on my COMMBOX?
- What does COMMBOX error code “SensErr 2” mean?
- What does COMMBOX error code “SensErr 1” mean?
Installation
- Does the waterproofing kit go above or below the membrane?
- How is the Warmup Waterproofing Kit installed?
- Do I need a waterproofing kit?