Is ultralight waterproof and sound proof?
You can stick the insulation boards to the concrete slab using regular modified or pre-mixed thin set. We recommend a 1/4 x 1/4” trowel.
Is ultralight waterproof and sound proof? Read More »
questions
Can multiple layers of Ultralight be installed?
Layering Ultralight Insulation Boards: Is it Possible? Ultralight cannot be layered because the thickness will double of amount of movement under the tile which means the floor will not meet the declared wear ratings. Pro Tip: If you need to add more height to the floor, use leveler to prepare the floor as needed,
Can multiple layers of Ultralight be installed? Read More »
How Big and How Heavy are Ultralight Boards?
You can stick the insulation boards to the concrete slab using regular modified or pre-mixed thin set. We recommend a 1/4 x 1/4” trowel.
How Big and How Heavy are Ultralight Boards? Read More »
Installing insulation boards over a Wooden Subfloor
There is a specific way to install the insulation boards over a wooden sub-floor. Click “Read More” to learn how.
Installing insulation boards over a Wooden Subfloor Read More »
Warmup Insulation Board Installation Video
See just how easy it is to install our floor heating insulation boards. Click here to watch our Insulation Board Installation Video.
Warmup Insulation Board Installation Video Read More »
Insulation Boards: Preparing for the Installation of Floor Heating
All surfaces should be thoroughly cleaned of all dirt and debris. When installing over an existing concrete base, it is important to remove all traces of existing finishes, contamination, etc. to allow for a clean surface.
Insulation Boards: Preparing for the Installation of Floor Heating Read More »
Make sure that the floor probe that came with the floor heating thermostat was installed and done so properly.
It is vital that the floor heating thermostat’s floor probe was not only installed but done so the right way. Click “Read More” for details.
Basic Installation of the In-slab Floor Heating Cable
Warmup In-slab Floor Heating Cable is designed to be placed within the cement slab of at least 2” (50mm) in thickness, with at least 11/8” (30mm) of the slab above the heating wire. For thicker pour of up to 6”, elevate the wire mesh on which the cable is tied with bricks, wood blocks or other spacers to float the cable at the desired level. Depending on the construction of the subfloor and in general, in order to improve the efficiency of the system, you may need to apply insulation prior to the pour.
Basic Installation of the In-slab Floor Heating Cable Read More »
Should I install the WIU with the foil side up or down?
WIU should be installed with the foil side facing DOWN. Click “Read More” for details.
Should I install the WIU with the foil side up or down? Read More »
Installation of WIU over various sub-floor types
Designed specifically to enhance the performance of the Foil Floor Heating Systems. Click “Read More” for installation.
Installation of WIU over various sub-floor types Read More »
![Thumbnail [200x250]](/wp-content/uploads/Indoor-Systems-Page-Image.png)
![Thumbnail [200x250]](/wp-content/uploads/image-13.png)
![Thumbnail [200x250]](/wp-content/uploads/Projects-Image.png)