Once your profile and 4iE are registered, you can now set up or edit a program through the MyHeating App. Note: You can set multiple different programs for different days. Refer the the video below for further guidance.
How to Set Up a Program Using the MyHeating App Read More »
There are two ways to add a Room to your account, which will serve as a way to register your 4iE thermostat to your profile.
The first way is through the my.warmup.com profile and the second way is directly through the MyHeating App.
How Do You Add a Room using the MyHeating App? Read More »
Warmup strongly recommends that the relay is installed in a separate single gang box to avoid overheating and interference of other cables. Check with your electrician and refer to your local code for specific installation requirements.
Can I Install the Relay-25 in the Same Electrical Box with my Thermostat? Read More »
Thermostats with an internal GFCI including the Warmup 4iE and WUDG will fulfill this requirement. If a non-GFCI thermostat like our Tempo thermostat is being used, a GFCI breaker will be required. Consult with your local electrician to make sure your installation is properly protected and meets National and Local Electrical Code.
Is GFCI (Ground Fault Circuit Interrupter) Required for Bathrooms? Read More »
There is no battery backup or capacitor in the 4iE, however, there is internal memory. Periodically the programming and date/time are stamped to a section of internal memory. This is then overwritten when the next stamp takes place. When the power is resumed following a power outage, the device will revert to the most recent stamp taken.
Does the 4iE have a Battery Backup? Read More »
You can opt into using the air probe instead of the floor probe if you are more concerned about trying to achieve a specific air temperature, usually for primary heat.
When Should I Select Air vs. Floor when Programming my 4iE Thermostat? Read More »
Yes, the sensor lead can be extended up to 200 meters using same gauge cable. Total resistance of the sensor cable must not exceed 10 ohms.
Can the ETOG Sensor Lead be Extended? Read More »
If using a DCM-PRO membrane, scrape/scratch and prime the vinyl to ensure bonding with a highly modified thinset and install the membrane directly to it.
Can I Install my Floor Heat over an Existing Sheet of Vinyl Floor? Read More »
Yes you can heat under glass tiles. The thin-set holds the heat. The glass (silicon) isn’t a very good conductor but the thin-set does the work.
Can you heat under Glass Mosaic Tiles? Read More »
The CDP-2 blinks when it is getting minimal power through the DS controller to power it.
Why does my CDP-2 Blink when my DS Controller has a Steady Green Light? Read More »
Warmup offers an extensive range of electric floor systems compatible with all floor types, rooms and projects.
![Thumbnail [200x250]](/wp-content/uploads/Indoor-Systems-Page-Image.png)
![Thumbnail [200x250]](/wp-content/uploads/image-13.png)
![Thumbnail [200x250]](/wp-content/uploads/Projects-Image.png)
