Ensure you have created your account and registered the thermostat using the Device Number. Click “Read More” for details.
Connected to the internet and getting the “!” message on 4iE Thermostat? Read More »
Instead, try pulling the cable off the mesh and spacing the cable every 2 or 2.5 inches apart. Consult your installation manual with further questions regarding where the cable or mat can be run.
Can I cut my floor heating mat if it’s too large? Read More »
That “Ground Fault” error on your thermostat after several years could indicate your floor heating system had been damaged during installation. Click “Read More” to learn why.
Are you getting a “Ground Fault” error after a few years? Read More »
It indicates that the thermostat is not set up correctly. Click “Read More” for details.
“ER1 Out” Thermostat Reading on the Display Read More »
The TDR Meter is used to measure the distance to an existing fault in the wiring of your heating system. It sends an electrical pulse into the connected cable, traveling along the cable until it reaches the fault and then that pulse is sent back to the TDR. The time it took for that pulse to reach the fault and travel back is measured and converted to a distance reading that will appear on the TDR Meter.
What is a TDR Meter and how do I use it? Read More »
Here is an example of how Warmup Heating Cable could be installed on a roof.
Warmup Heating Cable Installed on a Roof Read More »
Floor heating can work under nailed hardwood as well. Click “Read More” for detailed instructions to do it the right way.
Specialized installation – under Nailed Hardwood Read More »
This short video shows how to run Warmup De-Icing Heating Cable in a Downspout.
Running Warmup De-Icing Heating Cable in a Downspout Read More »
The COMMBOX-600 is a “Plug and Play” controlled power distribution panel for frost protection, ice and snow melting projects. When receiving a signal from the sensor(s)m the contactors are activated, energizing your heating system. DIP switch settings determine how the zones activate. When programming your system, make sure DIP switch 1 is in the ON position. The program manual can be navigated by using the SELECT (+) to move forward or SELECT (-) to go back through settings.
Programming your COMMBOX-600 Read More »
This short video by Warmup shows how to secure roof clips.
How To Secure Roof Clips by Warmup Read More »
Warmup offers an extensive range of electric floor systems compatible with all floor types, rooms and projects.
