To set up the Terra WiFi Thermostat with WiFi, follow the simple steps below. Using the print manual for assistance, use the up and down arrows to select your system type icon Click the tick to confirm selection Next, enter the input wattage Click the tick after each number to confirm Now select the […]
How do I set up the Terra WiFi Thermostat with WiFi? Read More »
If you’d like to set up your Terra WiFi Thermostat without WiFi, follow the simple steps below or watch the following video.
How do I set up the Terra WiFi Thermostat without WiFi? Read More »
Follow the video or simple steps below to turn off window detection on the Terra WiFi Thermostat.
How do I turn off open window detection on the Terra WiFi Thermostat? Read More »
If your thermostat has no display and will not turn on when power button is pushed, the thermostat could be wired incorrectly. Click here for more details.
What if my thermostat screen is black and won’t turn on? Read More »
If you purchased a Digital Multimeter from Warmup you will have 2 connectors as shown below. Please make sure that the contacts that will be plugged into the multimeter are properly exposed as illustrated below. It is possible that you may have to remove some of the sheathing from the connector ends to expose them enough to make the needed contact with the multimeter in order to receive accurate readings.
Check the Resistance Readings of your Electric Floor Heating System Read More »
Click “Read More” for details.
Why is my sensor still activated when it stopped snowing? Read More »
If your heating system was installed on a concrete slab or over an unheated space and insulation boards were not used, it is possible that the heat loss into the subfloor will cause your floors to heat up more slowly and possibly not reach the target temperature. Click “Read More” for details.
Why is my Floor not Reaching Target Temperature? Read More »
The resistance for your mat or cable is calculated on the length of the heater. Shortening the heater would increase the resistance and thereby the temperature. The cable is expected to operate fine at slightly higher temperatures for a time, but it may put undue strain on the end-splice, which may then trip and eventually fail.
Why does my thermostat trip every time it reaches the same temperature? Read More »
When applied, you will select a number and this percentage represents the number of minutes the heat will be on out of every 10 minute cycle. For example, if you select 60%, the heat will be on for 6 minutes, followed by 4 minutes of the system being off. Then, after the 4 minutes, it will activate again for 6 and so on. This will continue until your programmed heating period ends or until you manually turn off the heat.
Why does my thermostat read a percentage (Regulator Mode)? Read More »
This message will occur if a ground fault is detected. Click “Read More” for details.
Warmup offers an extensive range of electric floor systems compatible with all floor types, rooms and projects.
