To turn on your system once your thermostat has been installed, simply turn on the breaker. The thermostat screen will light up. After setting the basic parameters of the thermostat, select a steady temperature in manual mode for your first heating period to ensure the product heats up.
▶ Introducing the new 7iE Smart Thermostat
Watch Now
Installation
The only way to see if the cable is going to work and is not damaged is to use an ohmmeter to check the resistance between the heating conductors matches what it should be in the manual or on the box.
Need also to check and make sure that there is no resistance to the ground conductor.
Yes, two downspout hanger kits should be used to protect the heating cable from damage caused by sharp gutter edges and to provide strain relief for both on the way down and back up the gutter. Click “Read More” for details.
The factory joint MUST be installed in the floor. Click “Read More” for details.
consider tightening the triangles, whilst maintaining the proper height based on the overhang or use t-splices and end kits for downspouts so you do not have to use extra cable coming back up
When using a relay for your installation, its important to note that each relay will need its own dedicated 20 amp circuit.
Follow these simple instructions to install the floor sensor probe. Click “Read More” for details.