In order to properly mount your 4iE thermostat, you will need a back-box as well as a mud-ring. Warmup can recommend compatible items.
▶ Introducing the new 7iE Smart Thermostat
Watch Now
Wiring
Always make sure to encapsulate the factory joint in thin-set or floor leveler. It must never be inside the wall. Not doing this will result in irreparable damage to your floor heating system. Chisel out a channel deep enough in your subfloor to accommodate the thickness of the joint.
When multiple floor heating systems need to be controlled by one thermostat there are guidelines to follow. Click “Read More” for details.
Follow these simple wiring instructions. Always use a licensed electician. Click “Read More” for details.
Follow these simple mounting instructions. Click “Read More” for details.
The 120V coil of the WSM-63 is powered between the one leg of 240VAc and a neutral they. Do NOT run both hots to the WSM-63. Please refer to the installation manuals for further information.
Start Wiring your Thermostat by Pulling Power from Terminals 2 and 5 Wiring the WSM-63 and ETO2 together is a great way to be able to control the WSM-63 timer panel with a pavement sensor. Pull the power from Terminals 2 and 5 and input into the L and N on the ETO2 controller. […]
Wiring your Tempo thermostat is simple and straightforward.
The maximum length Warmup recommends you can extend your snowmelt systems lead is 90′.
Yes, the sensor lead can be extended up to 200 meters using same gauge cable. Total resistance of the sensor cable must not exceed 10 ohms.