Learn what the ER2 Error means on a Warmup 7iE Thermostat and how to resolve the error.
Troubleshooting
Learn what the lock icon on Warmup’s 7iE Thermostat means and how to clear it.
Learn how to reset your Warmup 7iE Smart Thermostat through the thermostat’s settings.
Are you experiencing an error on your thermostat? Read this guide for tips on 6iE troubleshooting.
Temperature Variation in Single Rail Towel Warmers The variation in temperature of a Single Rail Towel Warmer may be due to a few factors: Wiring Configuration: In single rail towel warmers, the heating element is typically a wire or cable that enters the rail at one end, loops around inside, and exits at […]
The dual cable tester (DCT) cannot be used to measure the resistance of the floor sensor because it is not scaled to measure that high. The result will be O.L.
If the 6iE displays a triangle with an exclamation mark (see below) a limit temperature has been set and it has been achieved.
The Dual Cable Tester monitors up to two cables concurrently and monitors the integrity of both the core to core and core to ground resistance. Throughout the installation, this device will provide a precise resistance reading(s) and flash/sound an alarm if the circuit(s) is interrupted.
The “Control Period” checks the difference in the current measured temperature and the set temperature in a proportional-integral algorithm to maintain a steady temperature.
Do you need to reset the WiFi on your Warmup snow melting controller? This post will take you step by step.