Where do I place the sensor probe when installing the DCM-PRO cables?
This page outlines the recommended installation methods for your installing your sensor probe.
Where do I place the sensor probe when installing the DCM-PRO cables? Read More »
questions
Where do I install the DCM-PRO Factory Joint?
This page explains the positioning of the factory joint to ensure a successful installation of your Warmup heating system.
Where do I install the DCM-PRO Factory Joint? Read More »
How long is the cold lead on the DCM-PRO cable?
The conductor cores and ground braid of the 10′ cold lead are factory joined in a water resistant joint assembly to each supply conductor and ground conductor of the unheated lead.
How long is the cold lead on the DCM-PRO cable? Read More »
Where do I run the cold lead and sensor probe during DCM-PRO installation?
The cold tail lead and the sensor probe should be run in separate conduits. This will prevent any interference from the cold tail lead affecting the temperature readings from the sensor probe.
Where do I run the cold lead and sensor probe during DCM-PRO installation? Read More »
What is the DCM-PRO cable made of?
This page describes the composition of the DCM-PRO cable and the different components that make up this heating system.
What is the DCM-PRO cable made of? Read More »
What is the correct DCM-PRO cable spacing?
This page explains the DCM-PRO spacing guidelines and recommendations.
What is the correct DCM-PRO cable spacing? Read More »
How do I test my NAMSR self-regulating cables?
This page explains the purpose of testing your self-regulating cables and how to perform these tests.
How do I test my NAMSR self-regulating cables? Read More »
What is the best way to lay asphalt over a Heated Driveway?
This is a summary of the recommended installation practices when installing asphalt over a Warmup heated driveway system.
What is the best way to lay asphalt over a Heated Driveway? Read More »
Where do I place the sensor probe when installing in-slab cable?
The thermostats sensor probe can be installed in a number of ways and must be housed in a separate conduit from the heating systems cold tail lead. Click “Read More” for details.
Where do I place the sensor probe when installing in-slab cable? Read More »
What is causing my thermostat to keep tripping requiring that I press the reset button?
One reason why your thermostat keeps tripping could be that you have GFI on the thermostat and the breaker simultaneously. Click “Read More” for details.
What is causing my thermostat to keep tripping requiring that I press the reset button? Read More »
![Thumbnail [200x250]](/wp-content/uploads/Indoor-Systems-Page-Image.png)
![Thumbnail [200x250]](/wp-content/uploads/image-13.png)
![Thumbnail [200x250]](/wp-content/uploads/Projects-Image.png)