The Peel & Stick Membrane requires a substrate to be smooth, clean, and dry for proper adhesion. The Peel & Stick Membrane will not bond if: The floor is NOT smooth The floor is NOT clean The floor is NOT primed with a suitable/compatible primer The floor is NOT dry A primer is REQUIRED on all […]
Do I need to use a primer with the Peel-&-Stick Membrane? Read More »
Are you experiencing an error on your thermostat? Read this guide for tips on 6iE troubleshooting.
6iE Troubleshooting 2025 Read More »
Temperature Variation in Single Rail Towel Warmers The variation in temperature of a Single Rail Towel Warmer may be due to a few factors: Wiring Configuration: In single rail towel warmers, the heating element is typically a wire or cable that enters the rail at one end, loops around inside, and exits at
Why do single rail towel warmers have temperature variations? Read More »
Nothing would happen if a thermostat is wired backwards. The thermostat will NOT be damaged in any way, including a the screen being black. That is because the thermostat’s relay is “normally open”, meaning there is no path for electricity to travel, so voltage would be present, but would stop there. The thermostat’s relay has to be closed in order for the circuit to be complete and current to flow.
What happens if a thermostat is wired backwards? Read More »
Overcurrent, Ground Fault Circuit Interrupter (GFCI), and Ground Fault Equipment Protection (GFEP) are all types of electrical protection equipment mechanisms, but they serve different purposes and operate in distinct ways. Attached is an explanation of each and their differences.
First, what is self leveler? Self-leveler is required to allow installation of small format tiles and other floor types such as glue-down wood and LVT’s, to be laid on top of the DCM-PRO System. When used, it must be a single pour, at least 10mm deep measured from the top of the castellation (total ½”
What self-leveler should I use? Read More »
No, unfortunately you cannot use one 240V circuit to supply power to ALL controls / heating mats. Since the thermostats have GFCI protection built-in, those areas / heating mats will need to be supplied with Non-GFCI Protected Circuits.
Ultralight Insulation Boards are not “soundproof,” but are an excellent product for the reduction of sound.
Are Ultralight Insulation Boards Sound Proof? Read More »
Tile Floor Deflection Traditionally, the accepted minimum requirement for floor rigidity is L/360 – before the tile underlayment is installed. The L/360 standard means that the floor should not deflect more than the “span” divided by 360. If the span of the joists is 10 feet (between supports), then the deflection should not be more
What is the acceptable deflection for a floor that will be tiled? Read More »
Yes, you can install Ultralight under Foil Heater Systems. While the Ultralight Insulation Board will deliver the best performance, the Warmup® Insulated Underlay may also be used as a more economical option for installation under a Foil Heater System. Warmup® FOIL systems are used to heat rooms under laminates, floating wood floors, and carpets. Refer
Can you install Ultralight Insulation Boards under a Foil Heater System? Read More »
Warmup offers an extensive range of electric floor systems compatible with all floor types, rooms and projects.
![Thumbnail [200x250]](/wp-content/uploads/Indoor-Systems-Page-Image.png)
![Thumbnail [200x250]](/wp-content/uploads/image-13.png)
![Thumbnail [200x250]](/wp-content/uploads/Projects-Image.png)
