Installation

How do I check if the cable is working ? The only way to see if the cable is going to work and is not damaged...

How many packages of fixing strips do I need? Are you installing the DCM-PRO cable without the DCM-PRO membrane? You will need fixing strips. This...

How long after flooring installation should we wait to use the heat? Are you wondering how long after installation you have to wait to begin using your floor...

How do I register a product warranty? If you are finalizing a Warmup installation it is almost time to register your warranty! Find...

Is there a video guide for installing the DCM-PRO system? Are you getting ready to install the DCM-PRO system? Check out this video for helpful tips...

How do I test my heating cable(s)? Warmup recommends testing your underfloor heating cables before, during, and after installation. Follow along with this...

What is the diameter of the DCM-PRO cable? If you are installing the DCM-PRO cable in your home you may be wondering about the...

Can the cable be spaced at 2 pegs? Each row in the membrane is referred to as a peg. Learn more here about minimum...

Should I leave space between membrane sheets? When installing sheets of Warmup membrane, you should try your best to install with no overlapping...

How do I know which voltage to run to my DCM-PRO cables? This page explains how to determine which voltage to run to your DCM-PRO heating system.

When should I check my resistance readings for the DCM-PRO cables? Outlined description of when to test your DCM-PRO cable and why you should do it.

Where do I place the sensor probe when installing the DCM-PRO cables? This page outlines the recommended installation methods for your installing your sensor probe.

Where do I install the DCM-PRO Factory Joint? This page explains the positioning of the factory joint to ensure a successful installation of your...

How long is the cold lead on the DCM-PRO cable? The conductor cores and ground braid of the 10' cold lead are factory joined in a...

Where do I run the cold lead and sensor probe during DCM-PRO installation? The cold tail lead and the sensor probe should be run in separate conduits. This will...

What is the correct DCM-PRO cable spacing? This page explains the DCM-PRO spacing guidelines and recommendations.

Can the cold tail lead of your Warmup indoor heating system be extended? This page explains how to extend your lead wire or connect your heater to a thermostat...

Can the lead of your Warmup heating system be trimmed? This page will give you pointers about trimming your cold lead to fit easier in the...